Hi, I'm using prevent duplicates, but I cannot change the numbering format at all. The problem is sometimes I end up with is hundreds of duplicates, so I need the first onr to be appended like "_001" then "_002" and so forth. This way, they would stay in the right order for many different types of software applications, versus _1 and _10 being shown as successive.
If theres a setting for this, I cannot find it. I looked in the .bru file and changed Start="1" to Start="001" but this does not work. So after the rename, I must then relist the files to carefully select _1 through _9 with Remove(5) the last 1 so Numbering(10) can fix them. That isnt so bad, but if theres more duplicates after _9, then I must again carefully select _10 through _99, and do it again with Remove(5) but change it to remove last 2, and then also change Numbering(10) to start at 10.
Anything over 100 is fine because its already in the proper format, but I really need a pad setting for the lower numbers if possible. Where to find this setting? Is there another way to get this done more quickly? Thanks in advance.