The files in the path I'm attempting to jump to are simple .txt files. I noticed this in previous versions and hoped it would be fixed when I updated, but no dice.
"Jump-to" doesn't work for Network folders?
2 posts • Page 1 of 1
"Jump-to" doesn't work for Network folders?
by jared592 » Fri Mar 21, 2008 3:40 pm
This is the only major problem I've had with this Utility, which is otherwise awesome. The status bar says the path was successfully jumped to, but even with repeated attempts to refresh, nothing is displayed.
The files in the path I'm attempting to jump to are simple .txt files. I noticed this in previous versions and hoped it would be fixed when I updated, but no dice.
The files in the path I'm attempting to jump to are simple .txt files. I noticed this in previous versions and hoped it would be fixed when I updated, but no dice.
- jared592
- Posts: 1
- Joined: Fri Mar 21, 2008 3:12 pm
Re: "Jump-to" doesn't work for Network folders?
by Admin » Fri Mar 21, 2008 4:27 pm
Network/UNC paths are not well supported in BRU, it's designed to operate across drive letters. This may change in a future release, as Microsoft is bringing out a decent "tree" control which will support UNC paths better than the current implementation.
Jim
Jim
- Admin
- Site Admin
- Posts: 2883
- Joined: Tue Mar 08, 2005 8:39 pm
2 posts • Page 1 of 1